This wiring harness is designed to be used for Chevrolet,
Ford, Chrysler, etc. This wire harness includes the basic
circuits such as starting, charging, ignition, gauges and
lighting for safety inspections. The lighting circuits are
high and low beam headlights, tail lights, park lights, turn
signals, stoplights and license light.
The 24 circuit wiring harness is the top of the line; it
has everything the 18 circuit has plus six additional circuits;
which are: under hood light, clock, lighter, dome light,
trunk light and glove box light. Just like the 12 and 18
circuit harness, you can also add circuits to this harness.
This wire harness also comes with the switches.
The 24 Circuits are:
1. Radio
2. Wipers
3. Turn Signals
4. Gauges
5. Stop Lights
6. Horn
7. Hazard Flasher
8. Tail Lights
9. Park Lights
10. Dash Lights
11. Distributor
12. Heat and A/C |
13. Power Windows
14. Power Locks
15. Electric Fan
16. Electric Fuel Pump
17. High Level Stop Light
18. Radio B+ Memory
19. Under Hood Light
20. Clock
21. Lighter
22. Dome Light
23. Trunk Light
24. Glove Box Light |
Easy Installation Features:
- Heavy 8 gauge alternator charge wire to accommodate 100
Amp plus alternators.
- All terminals are soldered to insure
reliability.
- Heavy 12 gauge starter circuit (This means
no hot start problems.)
- Heavy 12 gauge ignition circuit is compatible with any
ignition system and any fuel delivery system from a carburetor
to fuel injection.
- All wires are pre-connected
to fuse block.
- Fuses, flashers and horn relay are pre-installed.
- Fuse
block measures 7" x 4" and is flush mount.
It can be universally mounted with retaining screws at top
or bottom of fuse block.
- Fuse block has three accessory ports.
- Theft deterrent
system
- All switch controls are pre-wired and all connectors
are pre-installed: ignition switch (GM column type),
neutral safety switch (GM column type), headlight switch,
dimmer switch, stop light switch, turn signal switch (2
connectors provided-late GM column type), alternator connector
and 2 headlight pigtails .If not using GM components, instruction
sheet identifies each color wire and its function.
- Circuits
are GM design and wire is GM gauged and color coded.
- Enough
wire length to reach front to rear on all circuits
- No
extra parts to buy. Each system is complete with:
- Headlight switch, retaining nut, rod and knob
- Dimmer switch and mounting screws
- Stop light switch and mounting nuts
- Two turn signal switch connectors for late GM column
- Two headlight pigtails
- Alternator pigtail
- Fusible link to protect entire system
- Terminals and retaining screws
- Easy to follow instructions
Complete Wiring Harness - $369.00
Part# UH24
|
 |
